Installation guide

Appendix A Network Ports and Protocols
Note:
▪ You are notified by SystemPolicy (Manager) only when receiving an event.
▪ Contents of notification by SystemPolicy (Manager) is defined in the following file,
stored in the SystemProvisioning installation folder:
SystemProvisioning installation folder\conf\PvmCustom.xml
1.7.2. Machine Status / Set Ready Status
Configures the Hardware Status of a target machine to "Ready".
This action can be executed in parallel with other operations on the same machine.
1.7.3. Machine Status / Set Degraded Status
Configures the Hardware Status of a target machine to "Degraded."
1.7.4. Machine Status / Set Faulted Status
Configures the Hardware Status of t a target machine to "Faulted."
1.7.5. Machine Status / Set Faulted Status by Sensor Diagnosis
This action obtains hardware sensor information and analyzes it.
It sets Hardware Status to "Faulted" and ends normally if a sensor is in critical state.
Additionally, this action does not change hardware status and ends abnormally if any
sensors have no problems. If the next action’s execution condition is "Success", the
next action will not be executed.
Sensors are displayed in the Sensor tab. To display the Sensor tab, click the Resource,
the Machine icon, and the IPMI information on Configuration menu. Then, click the
Sensor on the IPMI Information screen. If a sensor’s Exclude from sensor diagnosis
check box is not selected, the sensor is a target of the sensor diagnosis.