Installation guide

Appendix A Network Ports and Protocols
Note:
▪ Policy actions for moving a single virtual machine are abolished with
SigmaSystemCenter 2.0. In substitution, policy actions for Power save Virtual Machine
server and Load balance Virtual Machine Server are added,
If you were using the abolished policy actions before upgrading SigmaSystemCenter,
the policy actions are converted to No action.
▪ You need to note the point below for the actions:
 Action for Group / Scalein Delete a machine from the group
 Action for Group / Delete a virtual machine from the group
 Action for Group / Scalein Suspend machines in the group
 Action for Group / Scalein Shutdown machines in the group
 Action for machine / Shutdown machine
 Action for machine / Diagnose and Power OFF
If the number of machines normally running at the target group is under the specified
minimum number (set in the Min Running Machine Count box), the job ends normally
with warning and no action is executed. If zero is set in the Min Running Machine Count
box, there is a possibility that the number of machines normally activated reaches zero.
For details of the actions, see the following subsections.
Reference: For details of actions which are executed in the process of changing
machine configuration, see Section 1.5, "Changes in Machine Configuration" in
SigmaSystemCenter Overview Reference Guide.
1.7.1. Notification/ E-mail, Event Log
Notifies detected contents and the start and result of actions by a policy by sending
emails and registering the event to the event logs.
Registering an event to the event logs and E-mail notification are commanded at the
timing of event detection, starting an action, or completing an action.
For details of setting E-mail destination address or other settings, see Subsection 2.4.2,
"Configuring the Mail Reporting" in SigmaSystemCenter Configuration Guide.
You cannot set E-mail notification and event log registration to each policy and event.
This action can be executed in parallel with other operations on the same machine.
The timings of notification, event log ID, and mail messages are as follows.
For the registration information according to event log ID, see Subsection 2.2.1, "Event
Logs of SystemProvisioning."