Technical data

VSPEX Configuration Guidelines
VMware Horizon View 5.3 and VMware vSphere for up to 2,000 Virtual
Desktops Enabled by Brocade Network Fabrics, EMC VNX, and EMC Next-
Generation Backup
150
Permanent Port Name: 50:06:01:6c:36:60:07:c3
Port Index: 10
Share Area: No
Device Shared in Other AD: No
Redirect: No
Partial: No
The Local Name Server has 2 entries }
Create Alias
SW6510:FID128:admin> alicreate
error: Usage: alicreate "arg1", "arg2"
SW6510:FID128:admin> alicreate
"ESX_Host_HBA1_P0","10:00:00:05:33:64:d6:35"
SW6510:FID128:admin> alicreate
"VNX_SPA_P0","50:06:01:60:b6:60:07:c3"
Create Zone
SW6510:FID128:admin> zonecreate
error: Usage: zonecreate "arg1", "arg2"
SW6510:FID128:admin> zonecreate
"ESX_Host_A","ESX_Host_HBA1_P0;VNX_SPA_P0"
Create cfg and add zone to cfg
SW6510:FID128:admin> cfgcreate
error: Usage: cfgcreate "arg1", "arg2"
SW6510:FID128:admin> cfgcreate "vspex", "ESX_Host_A"
Save cfg and enable cfg
SW6510:FID128:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on Defined configuration. Any
changes made on the Effective configuration will not take effect
until it is re-enabled. Until the Effective configuration is re-
enabled, merging new switches into the fabric is not recommended
and may cause unpredictable results with the potential of
mismatched Effective Zoning configurations.
Do you want to save Defined zoning configuration only? (yes, y,
no, n): [no] y
Updating flash ...
SW6510:FID128:admin> cfgenable "vspex"
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected. If the update includes changes
to one or more traffic isolation zones, the update may result in
localized disruption to traffic on ports associated with
the traffic isolation zone changes
Do you want to enable 'vspex' configuration (yes, y, no, n): [no]
y
zone config "vspex" is in effect
Updating flash ...