Technical data

VSPEX Configuration Guidelines
VMware Horizon View 5.3 and VMware vSphere for up to 2,000 Virtual
Desktops Enabled by Brocade Network Fabrics, EMC VNX, and EMC Next-
Generation Backup
139
Note: As this command was created primarily to benefit Network
Attached Storage devices (NAS). The commands used with this feature
use the term tures created primarily too strict requirement that these
nodes be actual NAS devices, as Auto QoS will prioritize the traffic for any
set of specified IP addresses.
There are four steps to enabling and configuring Auto QoS for NAS:
1. Enable Auto QoS.
2. Set the Auto QoS CoS value.
3. Set the Auto QoS DSCP value.
4. Specify the NAS server IP addresses.
For detailed instructions for setting this feature up, please refer to the
Network OS Administration Guide, v4.1.0.