Technical data

ManualsBrandsVMware ManualsOtherVCENTER CONFIGURATION MANAGER 5.3

131

132

133

134

135

136

137

138

139

140

VSPEX Configuration Guidelines

VMware Horizon View 5.3 and VMware vSphere for up to 2,000 Virtual

Desktops Enabled by Brocade Network Fabrics, EMC VNX, and EMC Next-

Generation Backup

137

BRCD6740-RB21(config)# interface port-channel 4

BRCD6740-RB21(config-Port-channel-4)# switchport

BRCD6740-RB21(config-Port-channel-4)# switchport mode trunk

BRCD6740-RB21(config-Port-channel-4)# switchport trunk allowed

vlan all

BRCD6740-RB21(config-Port-channel-4)# no shutdown

2. Use the channel-group command to configure interfaces as

members of a Port-Channel 4 to the infrastructure switches that

interface to the core.

BRCD6740-RB21(config)# in te 21/0/5

BRCD6740-RB21(conf-if-te-21/0/5)# channel-group 4 mode active type

standard

BRCD6740-RB21(conf-if-te-21/0/5)# in te 21/0/6

BRCD6740-RB21(conf-if-te-21/0/6)# channel-group 4 mode active type

standard

3. Repeat above steps 1-2 on Logical Chassis’ Principal Node Rbridge

21 to configure Port-Channel 4 on Rbridge 22’s interfaces 22/0/5

and 22/0/6.

4. Use the do show port-chan command to confirm that the vLAG

comes up and is configured correctly.

Note: The LAG must be configured on the MLX MCT as well before the

vLAG can become operational.

BRCD6740-RB21(config-Port-channel-4)# do show port-chan 4

LACP Aggregator: Po 4 (vLAG)

Aggregator type: Standard

Ignore-split is enabled

Member rbridges:

rbridge-id: 21 (2)

rbridge-id: 22 (2)

Admin Key: 0004 - Oper Key 0004

Partner System ID - 0x0001,01-80-c2-00-00-01

Partner Oper Key 30002

Member ports on rbridge-id 21:

Link: Te 21/0/5 (0x151810000F) sync: 1 *

Link: Te 21/0/6 (0x1518110010) sync: 1

BRCD6740-RB22(config-Port-channel-4)# do show port-channel 4