Specifications

Chapter 2: Installing SolarWinds Virtualization Manager
14. Right-click the virtual appliance, and then select Settings.
15. Select Network Adapter.
Note: Using a Legacy Network Adapter may cause degradation in network
connection: the web application might become inaccessible or the SSH
connection may break down. To verify that your network adapter is working
correctly, connect to the Virtualization Manager appliance by using the
Hyper-V Manager, and then run the ifconfig command. If the output of the
command shows that there are no dropped packets, the network adapter is
working correctly.
16. Specify the network settings the VM should use.
17. Click OK.
18. Start the VM.
19. Right-click the virtual appliance in the inventory, and then click Connect.
20. Select Set Timezone and ensure that the appliance is set to the same time
zone as the Hyper-V host server.
21. Open a browser to https://IPaddress:5480 where IPaddress is the
address of the virtual appliance server.
22. Log in, and then accept the End User License Agreement. The default
account is admin with the password admin.
23. Click Network, and then click Address.
24. If you use DHCP to determine the IP address of the appliance, verify that it
is selected.
25. If you use a static IP address, complete the following steps:
a. Enter the static IP of the virtual appliance.
b. Enter the net mask.
c. Enter the gateway.
d. Enter the DNS Server 1.
42