7.0
Table Of Contents
- Deploying and Configuring Access Point
- Contents
- Deploying and Configuring Access Point
- Introduction to Access Point
- System Requirements and Deployment
- Configuring Access Point
- Collecting Logs from the Access Point Appliance
- Setting Up Smart Card Authentication
- Setting Up Two-Factor Authentication
- Index
These settings are included in the EdgeServiceSettings resource. The URL is
https://access-point-appliance.example.com:9443/rest/v1/config/edgeservice/view
In this URL, access-point-appliance.example.com is the fully qualified domain name of the Access Point
appliance.
VMware recommends that you configure these settings at deployment time, by using the PowerShell scripts
attached to the blog post "Using PowerShell to Deploy VMware Access Point," available at
https://communities.vmware.com/docs/DOC-30835. Alternatively, you can configure these settings by using
the VMware OVF Tool directly. For an example, see “Using VMware OVF Tool to Deploy the Access Point
Appliance,” on page 23.
Chapter 3 Configuring Access Point
VMware, Inc. 45