User manual

Connecting to Remote Desktops
and Applications 2
You can use Horizon Client to connect to remote desktops and applications.
This chapter includes the following topics:
n
Setting the Certificate Checking Mode in Horizon Client
n
Connect to a Remote Desktop or Application
n
Connect to Published Applications Using Unauthenticated Access
n
Log Off or Disconnect
Setting the Certificate Checking Mode in Horizon Client
You can determine whether client connections are rejected if any or some server certificate checks fail by
configuring a setting in Horizon Client.
Note At some companies, an administrator might set the default certificate verification mode and prevent
end users from changing it in Horizon Client.
Certificate checking occurs for SSL connections between the server and Horizon Client. Certificate
verification includes the following checks:
n
Is the certificate intended for a purpose other than verifying the identity of the sender and encrypting
server communications? That is, is it the correct type of certificate?
n
Has the certificate expired, or is it valid only in the future? That is, is the certificate valid according to
the computer clock?
n
Does the common name on the certificate match the host name of the server that sends it? A
mismatch can occur if a load balancer redirects Horizon Client to a server that has a certificate that
does not match the host name entered in Horizon Client. Another reason a mismatch can occur is if
you enter an IP address rather than a host name in the client.
n
Is the certificate signed by an unknown or untrusted certificate authority (CA)? Self-signed certificates
are one type of untrusted CA.
To pass this check, the certificate's chain of trust must be rooted in the device's local certificate store.
VMware, Inc.
6