Installation and Setup Guide

Table 3‑9. Horizon Client Configuration Template: USB Filtering Settings (Continued)
Setting Properties
Exclude Device Family
Excludes families of devices from being redirected. The format of the seing is
family_name_1[;family_name_2]...
For example: bluetooth;smart-card
If you have enabled automatic device spliing, Horizon examines the device family of each
interface of a composite USB device to decide which interfaces should be excluded. If you
have disabled automatic device spliing, Horizon examines the device family of the whole
composite USB device.
The default value is undened.
This seing is in the VMware Horizon Client  > View USB 
folder in the Group Policy Management Editor.
Exclude Vid/Pid Device
Excludes devices with specied vendor and product IDs from being redirected. The format
of the seing is vid-xxx1_pid-yyy2[;vid-xxx2_pid-yyy2]...
You must specify ID numbers in hexadecimal. You can use the wildcard character (*) in
place of individual digits in an ID.
For example: vid-0781_pid-****;vid-0561_pid-554c
The default value is undened.
This seing is in the VMware Horizon Client  > View USB 
folder in the Group Policy Management Editor.
Exclude Path
Exclude devices at specied hub or port paths from being redirected. The format of the
seing is bus-x1[/y1].../port-z1[;bus-x2[/y2].../port-z2]...
You must specify bus and port numbers in hexadecimal. You cannot use the wildcard
character in paths.
For example: bus-1/2/3_port-02;bus-1/1/1/4_port-ff
The default value is undened.
This seing is in the VMware Horizon Client  > View USB  >
 not  by Agent folder in the Group Policy Management Editor.
Include Device Family
Includes families of devices that can be redirected. The format of the seing is
family_name_1[;family_name_2]...
For example: storage
The default value is undened.
This seing is in the VMware Horizon Client  > View USB 
folder in the Group Policy Management Editor.
Include Path
Include devices at a specied hub or port paths that can be redirected. The format of the
seing is bus-x1[/y1].../port-z1[;bus-x2[/y2].../port-z2]...
You must specify bus and port numbers in hexadecimal. You cannot use the wildcard
character in paths.
For example: bus-1/2_port-02;bus-1/7/1/4_port-0f
The default value is undened.
This seing is in the VMware Horizon Client  > View USB  >
 not  by Agent folder in the Group Policy Management Editor.
Include Vid/Pid Device
Includes devices with specied vendor and product IDs that can be redirected. The format
of the seing is vid-xxx1_pid-yyy2[;vid-xxx2_pid-yyy2]...
You must specify ID numbers in hexadecimal. You can use the wildcard character (*) in
place of individual digits in an ID.
For example: vid-0561_pid-554c
The default value is undened.
This seing is in the VMware Horizon Client  > View USB 
folder in the Group Policy Management Editor.
Chapter 3 Configuring Horizon Client for End Users
VMware, Inc. 59