Specifications

CHAPTER 7 Networking
237
Note: On a Windows host, you may skip the steps for configuring network
addresses manually and, instead, use GSX Server’s DHCP server. Choose Host >
Virtual Network Settings > DHCP and add VMnet2 and VMnet3 to the list of
virtual networks served by the virtual DHCP server. Then skip to step 9.
On a Windows host, open a command prompt on the host computer and run
ipconfig /all. Note the network addresses used by each virtual adapter.
On a Linux host, run ifconfig at the console or in a terminal window on the
host computer. Note the network addresses used by each virtual switch.
7. Launch a console, open each virtual machine in turn and install the appropriate
guest operating system.
8. Configure the networking in each guest operating system.
For the bridged Ethernet adapter in virtual machine 1, use the networking
settings needed for a connection to the external network. If the virtual machine
gets its IP address from a DHCP server on the external network, the default
settings should work.
For the second Ethernet adapter in virtual machine 1, manually assign an IP
address in the range you are using with VMnet2.
In virtual machine 2, assign an IP address in the range you are using with
VMnet2.
In virtual machine 3, network adapters are connected to VMnet2 and VMnet3.
Assign each adapter an IP address in the range you are using with the virtual
network to which it is connected.
In virtual machine 4, assign an IP address in the range you are using with
VMnet3.
9. Install the necessary application software in each virtual machine.