Specifications

Trend Micro™ Smart Protection Server 2.5 Installation and Upgrade Guide
4-6
How Do I Change the Smart Protection Server IP Address?
To change an IPv4 address:
1. Log on to the Command Line Interface (CLI) using admin.
2. Type the following commands:
enable
configure ipv4 static <new ipv4 add> <subnet> <v4gateway>
3. Verify the changes by typing the following command:
show ipv4 address
4. Restart the machine.
To change an IPv6 address:
1. Log on to the Command Line Interface (CLI) using admin.
2. Type the following commands:
enable
configure ipv6 static <new ipv6 add> <prefix> <v6gateway>
3. Verify the changes by typing the following command:
show ipv6 address
4. Restart the machine.