Instructions

Step 1

Before starting, lay out all parts to your mount and match them to the

parts list provided. Verify that you have all your parts before attempt-

ing to assemble the mount.

Step 2

Assemble the wall plate by attaching the two horizontal wall plates

using the vertical supports and short M4 screws . You

can identify the difference between the top and bottom rail by the

fact that the top rail is the one with the stopper aps on either end.

Step 3

Mark the wall or desired mounting surface in preparation of installation

of wall plate assembly and . If mounting to wooden studs, pre

drill pilot holes using a 7/32” drill bit. Attach the wall plate assembly

and to the wooden stud using the 5/16” by 2.5” long lag screw

and washer making sure the folded tabs on the wall plate as-

sembly are towards the top. WARNING: Please verify that your mount-

ing surface will support the combined weight of your mount, mounting

hardware, and at panel. Also verify that the mounting surface is safe

to drill through. Please note only mounting hardware for mounting to

wooden studs will be provided with the unit. If mounting to a surface

other than wooden studs then other hardware will be required. If in

doubt or uncertain about any of the above, please contact a profes-

sional installer.

Step 4

Determine the correct screw size and if you need to use washers, lock

washers, or spacers. Note: Spacers are used for TVs with recessed

hole patterns. Secure the display to the tilt bracket using the ap-

propriate hardware through . Note: The brackets have to be

level with each other to work properly.

Step 2: Assembling the wall

plate

Step 3: Mounting the wall plate

Step 4A: Attaching the tilt brackets to the screen

(spacers not needed)

Step 4B: Attaching the tilt brackets to the screen

(spacers used due to recessed hole pattern)