User guide

82
M5000 Series: User Guide
Issued June 20, 2007
Universe IID Configuration Examples
VMEbus Register Access Image
In this configuration example, the VMEbus Register Access Image is set up by use of the DIP
switch and jumpers.
With the jumper settings described above, the Universe IID will power up in a state where VMEbus
accesses with A24 AM codes, in the address range 0x0-0xFFF, will map into Universe II registers.
The VME_RAI will be utilized to set up the VMEbus slave images described below.
VMEbus Slave Image 0
In this configuration example, the VMEbus Slave Image 0 is set up to map A16 supervisory
accesses, in the address range 0x0-0x4FFF, from VMEbus to Configuration Cycles on the PCI bus.
1) This column shows write data for configuration from PCI
TABLE B-1. VME_RAI Setup
Action: Result:
SW3-3 ON VME_RAI is enabled.
SW3-1 ON, SW3-2 OFF VME_RAI is mapped in A24 address space.
SW5 All OFF VME_RAI base address is set to 0x000000.
SW11-2 OFF Disable Auto-slot ID protocol.
TABLE B-2. VME Slave image 0 - setup
Write from VME PCI Data 1) Result:
D:0x0000.0000 to A:0x000F04 0x0000.0000 Base Address set to 0x000000
D:0x0050.0000 to A:0x000F08 0x0000.5000 Bound Address set to 0x005000
D:0x0000.0000 to A:0x000F0C 0x0000.0000 Translation Offset set to 0x000000
D:0x0200.E080 to A:0x000F00 0x80E0.0002 Enable Image, VAS=A16, LAS=Config Space,
PGM=both, SUPER=Supervisor, other options
disabled.