User`s manual

HEADSPEAKER – 5.1 HEADPHONE SYSTEM
3. S oft w are In stallation
Connecting the DSP unit to a computer's USB port will initiate the installation of required
system drivers. To make personal adjustments, it is highly recommended to install the
provided diagnostic software also.
To install the diagnostic software, place the provided installation disc in the disc drive.
Installation procedure should start automatically. If it doesn't, autorun feature is
disabled in the operating system. In this case, view the contents of the installation disc
in file browser and launch the installer program manually.
Installer program will start by presenting a list of optional components to install. It is
advisable to make a full install. Next, the program allows to define a destination
directory. When you're ready, click install to finish the installation.
3.1 S o und S etting s Under Windo w s X P
After the software installation has completed, attach the DSP unit to a vacant USB port.
System should automatically identify the device and install any necessary hardware
drivers. After that, please make sure that HeaDSPeaker has the default sound device
status.
• Launch control panel from the Start menu.
• Open sound devices. A window similar to that shown in figure 8 should pop up.
Page 9