User Manual

Snipe
Recommendations for assembly
4
2.4 Incorporation of tail surface control cables
Insert the wire through the hole on the control horm. Using
a tube for cables (which you'll find in the accessories kit) with
a pair of pliers to crimp the cable as photo 2.10-2.11
To make a draft of the stabilizer of a cable loop and crimp
its tube for fixing the rope. (Fig. 2.12, 2.13).
For assistance in assembly, attach a 100 mm thread to the
elevator cable. You can lock the thread on the tail boom with
tape and pull it out of the slot in the fuselage for assembly of
the model. (Fig. 2.13)
Figure 2.12 - Preparation for the cable stabilizer
Figure 2.13-The thread on the cable of the elevator
Figure 2.10 - Cable on rudder
Figure 2.11 - Crimping tube cable
Fig. 2.14 - Cable stabilizer