User Manual

Snipe

Recommendations for assembly

Figure 2.6 - Sizing torsion feathers

Figure 2.5 - Insert the torsion bar in the tail

2.3 Inset kylya in hvostovuyu beam

Fix the rudder at zero deflection with masking tape.

For the vertical tail, install it vertical relative to the

stabilizer and wing (Fig. 2.8), and center it with respect to the

boom. (JW note: I offset mine about 1 cm upwards compared

to centered). Glue the fin into the groove of the fuselage with

superglue. (Fig.2.9)

(JW – I put a small fiberglass patch over the fuselage onto

the fin to increase the durability of the fin bond)

When bonding fin note:

- because airfoil is not symmetric, we make two versions

of the fuselage keel with grooves right-handed and left-

handed. Fig. 2.7 shows a view on the fuselage below

Figure 2.9 – Bonding fin

Figure 2.7 - Two versions of the fuselage (bottom view)

Figure 2.8 Set fin perpendicular to the axis of the fuselage