Service manual

S ECTION 5 – REPLACING COMPONENTS

CAFFÈ MIO – OPERATION AND SERVICE Page 86 of 110

Replacing Major Components

g) Install the drip tray detection and overflow bracket onto the slots at the inside bottom of the

front door, and tighten the screws to secure the bracket in place. Make certain the probes and

switch arm are placed in their proper position.

h) Once certain that all the wiring connections have been made, re-install the front board cover,

making sure it the mounting screw passes through the key-hole slot on the cover. Tighten the

screw to secure the cover in place.

7. Re-install the inner door by aligning and sliding the inne r door hinges onto the machine

cabinet hinges (note that these are the same hinges used for the front door).

8. Re-install the drip tray assembly onto the front door.

Position of

Switch Arm

Position of

Overflow

Probes

Tighten

Front Board

Cover