Service manual

S ECTION 5 – REPLACING COMPONENTS
CAFFÈ MIO – OPERATION AND SERVICE Page 72 of 110
Replacing Major Components
8. To install the ne w dis pe nser, lower in into position from the top of the machine and align the
couple r at the re ar of the dis pe nser with the drive pin on the dispenser motor.
9. Slide the rear of the dispenser support into the cutout on the base, and push the dispenser back
to couple it with the motor. The pin at the bottom of the dispe nse r will go into the notch on the
base to help guide the dispenser into position.
Support Cutout
Coupler
Drive Pin
Ingredient Dispenser
Dispenser Motor
Support Cutout
Notch
Guide Pin
Dispenser Base
Ingredient Dispenser
Support