Service manual

S ECTION 5 – REPLACING COMPONENTS
CAFFÈ MIO – OPERATION AND SERVICE Page 59 of 110
Replacing Major Components
16. Connect the inlet valve hose to the inlet fitting (rear fitting) at the bottom of the wate r tank, and
use a hose clamp to secure it in place. Make sure the drain plug is also down and locked.
17. Connect the respective hoses to all three outlet valves.
a) Remove the coffee hose from the brewer and connect it to the coffee valve.
18. Connect the power and ground wires to each of the outlet valves.
WIRES
CONNECTED TO:
#2 and #1-7 (#13-5 is ground)
Hot Water Valve
#3 and #1-8 (#13-6 is ground)
Chocolate Valve
#4 and #1-6 (#13-4 is ground)
Coffee Valve
Hot Water Hose
Chocolate Hose
Coffee Hose
#1-7
#2
#1-6
#4
#1-8
#3
#13-6
#13-4
#13-5
Inlet Hose
Install Clamp
Drain Plug Down