Service manual

S ECTION 5 – REPLACING COMPONENTS
CAFFÈ MIO – OPERATION AND SERVICE Page 58 of 110
Replacing Major Components
14. Connect the temperature probe harness to the rear circuit board.
a) Route the harness down the front of the water tank and connect it to the rear circuit board.
15. Connect the wires identified in the table and photo be low.
WIRE #
CONNECTED TO:
#11-2
Heater element
#14
Thermal cut-off sw itc h
#1-2
Level probe - long
#4-3
Level probe - long
#5-2
Level probe - short
Temp. Probe Harness
#4-3
#5-2
#11-2
#14
#1-2