Service manual

S ECTION 5 – REPLACING COMPONENTS
CAFFÈ MIO – OPERATION AND SERVICE Page 53 of 110
Replacing Major Components
11. Re-connect the two brewer harnesses and the ground wire to the rear board.
12. Re-install the brewer bracket assembly onto the left wall of the machine.
a) Make sure the bracket goes over the three loosened screws.
b) Tighten the screws to secure the bracket to the wall.
13. Replace the brewer.
a) See “
Replacing the Brewer” section for more details.
Rear Circuit
Board
Brewer Harness
Brewer Harness
Ground Wire
Tighten
Tighten
Tighten
Brewer Bracket