Service manual

S ECTION 5 – REPLACING COMPONENTS
CAFFÈ MIO – OPERATION AND SERVICE Page 50 of 110
Replacing Major Components
Brewer Bracket / Brewer Motor
1. With the machine power OFF, remove the brewer.
a) See “
Replacing the Brewer” section for more details.
2. Remove the brewer bracket.
a) Loosen, but do not remove, the three screws from the left side of the brewer bracket.
b) Lift the bracket clear of the screws and pull it away from the wall.
c) Disconnect the two brewer harnesses and the ground wire from the rear board.
Loosen
Loosen
Loosen
Brewer Bracket
Rear Circuit
Board
Brewer Harness
Brewer Harness
Ground Wire