Specifications

Eccellenza Pod Operation Manual

Plumbing the Machine

1. Specifications and Limitations:

The total overall length of installed section of water tubing should never exceed 25 feet (7.6 meters)

per unit. In the event more than 25 feet (7.6 meters) of conduit tubing is required, as measured from

the water supply connection (building plumbing) to the brewing equipment or cooler unit, the customer

should be required to sign a waiver document thus releasing your company from any and all

responsibility in the event damage is incurred as a result of a water leak from installed water tubing

and/or fittings and/or equipment.

2. Water Supply & Tubing - Material Requirements (Conforms to NSF-51 & NSF-61):

NOTE: The main water supply pressure must be between a minimum of 20 psi and a maximum of 100

psi.

Water supply connection (building plumbing to water tubing conduit):

► PREFERENCE: 2” copper shunt & compression tee fitting (multi unit location)

► ALTERNATE: Self-piercing valve (single unit locations only)

Water tubing (water supply to water filter – water filter to brewing equipment):

► NSF CERTIFIED: 3/8” I.D. Reinforced PVC Beverage grade hose tubing

3. Water Filter - Material Requirements (Conforms to NSF-42 & NSF-53):

Water filter & filter head:

► NSF CERTIFIED: EVERPURE 4H, or 4K-Plus, or 2K-Plus, or OCS

► An Everpure QL3 head with integrated shut-off valve must be installed

Installation of this equipment must comply with all local, state/provincial

and federal plumbing codes. It is the responsibility of the installer (and not

VKI Technologies) to research and to comply with all of these codes.

NOTE: When installing the machine onto a cabinet or countertop, ensure that

the machine is level.

NOTE: Accessibility to shut-off valve(s) must be provided and explained to

customer in the event water supply to brewing or cooler equipment must be

shut off.

NOTE: For multi-unit locations whereby the main water conduit is supplying

water to more than one unit (including water coolers), a separate in-line

shut off valve must be installed onto each individual equipment unit.