Package List

ManualsBrandsVJOYCAR ManualsAutomotiveCar Alarm

Car Alarm System

I. Package List (not work for 12V cars)

1* Siren

1* Antenna

1* Car Adaptor Air Sensor

1* 1-Way Remote Control

1* 2-Way Remote Control

II. Install

a. Siren

Step 1: Open the engine cover, find a suitable location (the steel housing

should be more than 2.5mm), clean the location of the steel housing.

Step 2: Attach the magnet siren onto the clean steel housing.

Step 3: connect the red cable to engine battery +, and connect the black

cable to engine battery -, and sort out the left cables.

Attention: let the siren face to down to avoid the water will be in the siren;

keep the siren some distance from the car engine to avoid terrible high

temperature.

b. Antenna

Step 1: install the antenna on the back side of the review mirror. Before

install, make sure the review mirror back side is clean enough, paste it very

much, to avoid the antenna fall off. Then pass the antenna cable lead

Summary of content (6 pages)

PAGE 1
Car Alarm System I. Package List (not work for 12V cars) 1* Siren 1* Antenna 1* Car Adaptor Air Sensor 1* 1-Way Remote Control 1* 2-Way Remote Control II. Install a. Siren Step 1: Open the engine cover, find a suitable location (the steel housing should be more than 2.5mm), clean the location of the steel housing. Step 2: Attach the magnet siren onto the clean steel housing. Step 3: connect the red cable to engine battery +, and connect the black cable to engine battery -, and sort out the left cables.
PAGE 2
through the edge of the windshield through the inside of the A-pillar trim. Stay on a horizontal line Step 2: After the antenna is introduced into the engine compartment of the vehicle, connect it to the female antenna of the siren, and wrap the connection with electrical tape after the docking. Then straighten the antenna and keep it away from the grounding metal inside the car engine, so that the receiving distance will be more far. c. Car Adaptor Air Sensor Step 1: Switch the button to “on”.
PAGE 3
After 6 seconds, the vibration and air pressure are detected, and after 35 seconds, the voltage drop is detected. --When system is under arm: press the button, it will 2 beep and disarm.
PAGE 4
beep 4 times; if it is triggered by a large vibration, the horn will beep 5 times; if it is triggered by air pressure, The horn makes 6 beeps; if it is triggered by a voltage drop, the horn makes 7 beeps. ③Button means: check the working status.
PAGE 5
There are four modes to choose. For example, if the horn beeps once, it means that mode 1 is selected, as follows： Mode 1 (call once): Allow vibration trigger (factory value) Mode 2 (called twice) allows voltage drop trigger Mode 3 (called three tones): Allow vibration triggering and voltage drop triggering Mode 4 (called four tones): prohibit both vibration and voltage drop triggering Factory default setting is: vibration triggering.
PAGE 6
Federal Communications Commission Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.