VIZULO Heron LED exterior luminaire Mounting instruction Montāžas instrukcija Mонтажная инструкция 05 IEC EN 60598 IP65 IK08 min − 40°C max + 50°C (+ 35°C)* 220 - 240 V AC 19 * Depends on configuration. Check label or technical specification. * Atkarīgs no konfigurācijas. Skatīt marķējumu vai tehnisko specifikāciju. * Зависит от конфигурации. Смотреть маркировку или техническую спецификацию. 4 3 24-03-2022 SIA VIZULO Laucu Lejas, Iecava, Latvia, LV-3913 www.vizulo.
Dimensions Izmēri Размеры Without flance ø20 50 60 650/1000/1200 ø13 35 120 ø12 80 With flance 50 250 200 650/1000/1200 200 ø60 120 ø16.5 ø12 80 Average Netto Weight Vidējais Neto Svars Cредний Нетто Вес HR HR HR HR HR HR BC 008 BC 008 BC 008 BC 008 BC 008 BC 008 * 065N * 065L * 100N * 100L * 120N * 120L *ZN/CB 7.9/2.4 Kg 9.6/2.9 Kg 11.5/3.6 Kg 13.2/4.1 Kg 13.3/4.3 Kg 15.0/4.
Acceptable luminaire mounting angle relative to the ground. Unacceptable luminaire mounting angle relative to the ground.
A stencil of mounting holes for HERON without flance Montāžas urbumu trafarets priekš HERON bez flanča Трафарет монтажных отверстий для HERON без фланца A stencil of mounting holes for HERON with flance Montāžas urbumu trafarets priekš HERON ar flanci Трафарет монтажных отверстий для HERON с фланцем The luminare itself can be used as a stencil: • place it on the desired mounting location; • mark the actual mounting holes; • drill the mounting holes; • insert wedge screws; • place the luminaire on and screw it
Standard configuration Standarta konfigurācija Стандартная конфигурация 1 Make the holes with a given diameter in a concrete base Idariet caurumus ar doto diametru betona pamatnē Сделайте отверстия с указаным диаметром в бетонном основании 60 50 ø12 35 2 Hammer the screws in a concrete base and place the luminaire Iesitiet skrūves betona pamatnē un novietojiet gaismekli Вбейте болты в бетонное основание и поставьте светильник 6/9
3 Unscrew the back panel and screw the screw nuts Atskrūvējiet aizmugurējo paneli un pieskrūvējiet uzgriežņus Открутите заднюю панель и прикрутите гайки 1 2 50Nm 4 19 4 1 2 3 Conductor cross section: 0.5 - 2.5 mm2 Conductor cross section: 0.5 - 4.0 mm2 Cables diameter: 7.0 - 12.0 mm Cables diameter: 8.0 - 12.
MCB/Inrush current table | Palaišanas strāvu tabula | Tаблица пусковых токов Tridonic LED driver (No dim/ Midnight dimming/ DALI) In-rush current Standard/High density (peak/dura�on) 6-12 LED, 8-26W 15 A (226 μs) 12-20 LED, 20-43W 25 A (236 μs) 20-28 LED, 30-64W 32 A (335 µs) 28-48 LED, 45-96W 42 A (238 µs) 48-64 LED, 70-144W 65 A (268 µs) 64-108 LED, 100-211W 80 A (225 µs) 108-128 LED, 135-288W 130 A (268 µs) 128-160 LED, 200-380W 160 A (225 µs) Eco 4-4 LED, 9-20W 4-8 LED, 20-38W 8-12 LED, 30-57W 12-24 LED
Terms of use and maintenance Before luminaire is turned on, it should be mounted according with this mounting instruction or any other applicable regulations. Mounting instructions Mounting of luminaire must be performed by a qualified person according with following instructions: • The warranty of luminaire does not apply, if the mounting of luminaire has been performed in precipitation (rain, snow, hail).