User Manual
Table Of Contents
- VIZIO 2.1 Sound Bar User Manual
- Accessibility ,
- IMPORTANT SAFETY INSTRUCTIONS ,
- TABLE OF CONTENTS ,
- Package Contents ,
- Controls & Connections ,
- First-time Setup ,
- Back of Subwoofer
- 1 Choose the best possible connection cable type and connect it to your TV.*
- 2 Connect the power cable to the sound bar AC IN as shown.
- 3 Connect the power cable to the subwoofer.
- 4 Plug the power cable into a power outlet.
- 5 The subwoofer should automatically power on and link to the sound bar when plugged in. The LED will glow to solid to confirm.
- 6 Remove the battery cover by gently sliding it away from the remote.
- 7 Insert the included batteries and gently slide the battery cover back into place.
- 8 After turning on both your TV and sound bar, it will automatically begin searching for an active input.* The LED indicator on the front of the sound bar will begin cycling in different colors through inputs until an audio source is detected. Double Asterisk
- Using the Remote ,
- Proper Placement ,
- Mode & Level Settings ,
- Using Button Combinations ,
- Programming the Sound Bar ,
- Bluetooth Pairing ,
- Using Bluetooth Mode ,
- Connecting to a Voice Assistant ,
- Advanced Setup ,
- Connecting a Subwoofer ,
- 1 First confirm that the power LED is illuminated. Press and hold the ON/OFF button on the back of the subwoofer for 5 seconds. The LED on the back of the subwoofer will begin to blink.
- 2 Press and hold the Power button on the top of the sound bar for 5 seconds. The LED indicators on the front will flash 3 times. The subwoofer is now linked with the sound bar.
- Product Registration and Support ,
- Help & Troubleshooting ,
- Limited Warranty ,
- UNITED STATES
- How Long This Warranty Lasts
- What This Warranty Covers
- How to Get Service
- Your Obligations Before Service
- VIZIO’s Responsibilities
- Types of Service
- What This Warranty Does Not Cover
- What to Do If You Are Not Satisfied With Service
- Binding Arbitration Agreement; Class Action Waiver (U.S. Residents Only)
- Opt-Out Instructions
- Exclusions and Limitations
- How the Law Applies
- General
- Changes to Warranty
- Legal & Compliance ,
- Specifcations ,
Using Button Combinations
There are other functions that are triggered by different button combinations on the sound bar.
Buttons are located here.
Function LED Behavior Description
Factory
Reset
All LEDs will
ash 3 times
Reset the sound bar to the factory default settings. To perform a Factory Reset,
Press and Hold the Bluetooth( ) and Volume Down buttons for 5 seconds. (—)
Note: This will erase all settings and preferences that you have set.
VIZIO TV Remote
Control
Enable VIZIO
TV remote
Disable VIZIO
TV remote
Enable/disable the use of a VIZIO TV remote control to power on and adjust the volume
of the sound bar. To enable/disable this function, Press and Hold the Power ( ) and
Volume Up buttons for 5 seconds. ( + )
Eco Power Mode
Enable
Eco Power
Disable
Eco Power
When the Eco Power mode setting is enabled, the sound bar will automatically
power down after a period of inactivity. When disabled, the sound bar will remain
powered on until you turn it o. To enable/disable this function,
Press and Hold
the
Power
( ) and Volume Down buttons for 5 seconds. (—)
Note: Eco Power Mode setting is OFF by default.
Speaker Test
—
Press and Hold
the Bluetooth( ) and Volume Up buttons for 5 seconds.
A voice will begin calling out each speaker beginning with left (
Left, Right, and
subwoofer-white noise
). If any of these are missing, check the connection and run the
speaker test function again.
(+)
ENG - 14