User Manual
Table Of Contents
- VIZIO 2.1 Sound Bar User Manual
- Accessibility ,
- IMPORTANT SAFETY INSTRUCTIONS ,
- TABLE OF CONTENTS ,
- Package Contents ,
- Controls & Connections ,
- First-time Setup ,
- Back of Subwoofer
- 1 Choose the best possible connection cable type and connect it to your TV.*
- 2 Connect the power cable to the sound bar AC IN as shown.
- 3 Connect the power cable to the subwoofer.
- 4 Plug the power cable into a power outlet.
- 5 The subwoofer should automatically power on and link to the sound bar when plugged in. The LED will glow to solid to confirm.
- 6 Remove the battery cover by gently sliding it away from the remote.
- 7 Insert the included batteries and gently slide the battery cover back into place.
- 8 After turning on both your TV and sound bar, it will automatically begin searching for an active input.* The LED indicator on the front of the sound bar will begin cycling in different colors through inputs until an audio source is detected. Double Asterisk
- Using the Remote ,
- Proper Placement ,
- Mode & Level Settings ,
- Using Button Combinations ,
- Programming the Sound Bar ,
- Bluetooth Pairing ,
- Using Bluetooth Mode ,
- Connecting to a Voice Assistant ,
- Advanced Setup ,
- Connecting a Subwoofer ,
- 1 First confirm that the power LED is illuminated. Press and hold the ON/OFF button on the back of the subwoofer for 5 seconds. The LED on the back of the subwoofer will begin to blink.
- 2 Press and hold the Power button on the top of the sound bar for 5 seconds. The LED indicators on the front will flash 3 times. The subwoofer is now linked with the sound bar.
- Product Registration and Support ,
- Help & Troubleshooting ,
- Limited Warranty ,
- UNITED STATES
- How Long This Warranty Lasts
- What This Warranty Covers
- How to Get Service
- Your Obligations Before Service
- VIZIO’s Responsibilities
- Types of Service
- What This Warranty Does Not Cover
- What to Do If You Are Not Satisfied With Service
- Binding Arbitration Agreement; Class Action Waiver (U.S. Residents Only)
- Opt-Out Instructions
- Exclusions and Limitations
- How the Law Applies
- General
- Changes to Warranty
- Legal & Compliance ,
- Specifcations ,
First-time Setup
6
Remove the battery cover by gently
7
Insert the included batteries and gently
sliding it away from the remote. slide the battery cover back into place.
To p To p
When needed, VIZIO recommends replacing the batteries that came
with this remote with two, new Duracell ‘AAA’ alkaline batteries.
8
After turning on both your TV and sound bar, it will automatically begin searching for an active input.
*
The LED indicator on the front of the sound bar will begin cycling in different colors through inputs
until an audio source is detected.
**
Tip: Pressing the INPUT button will stop the auto
detect function.
Power
Input
Press the INPUT button to switch between audio sources. For
example, if you connected your TV to Optical, set the sound bar
to Optical.
*Occurs only during rst-time set up.
**Auto detect function only occurs once when the sound bar is rst powered on. To enable this feature
again, you must do a Factory Reset (see the Using Button Combinations on page 14 for more
information) or press and hold the INPUT button for 4 seconds.
ENG - 9