Quick Start Guide

English - 10
Turn on your TV and Sound Bar. The Sound Bar will automatically
begin searching for an active input.*
The LED indicators on the front of the Sound Bar will begin cycling in
triplets through inputs until an audio source is detected.**
You can press the INPUT button to switch between audio sources.
For example, if you connected your TV to AUX , set the Sound Bar
to AUX .
3
Remove the battery cover by gently
sliding it away from the remote.
4
Insert the included batteries and gently
slide the battery cover back into place.
5
Top Top
Tip: Pressing the INPUT button will stop the auto
detect function.
*Occurs only during rst-time set up.
**Auto detect function only occurs once when the Sound Bar is rst powered on. To enable this feature again, you
must do a Factory Reset (see the Using Button Combinations section for more information) or press and hold the INPUT
button for 3 seconds.
When needed, VIZIO recommends replacing the batteries that came
with this remote with two, new Duracell ‘AAA’ alkaline batteries.
Input
Power