Service manual

Drives without Load Handles
1-72 Revision P 96041
Sun Confidential - Internal Only
To replace the bezel:
2. Rotate the bezel away from the drive faceplate until the bezel is free.
1. Tabs
2. Target
1
L201_602
2
1. Orient the bezel with the target downward.
2. Holding the bezel at an angle to the drive faceplate, insert the left end tabs into the slots at the left
end of the cartridge port.
3. Rotate the bezel against the drive faceplate while pressing on the left end to ensure the bezel seats
against the drive faceplate.
4. Snap the right end tabs into their slots.
5. Check that the bezel is against the drive faceplate at the left end.