Service manual

96041 Revision P 1-71
Sun Confidential - Internal Only
Drives without Load Handles
To replace the bezel:
SDLT 600 Bezel
To remove the bezel:
1. Tabs
2. Target
1
L201_601
2
1. Orient the bezel with the target downward.
2. Hold the bezel parallel to the drive faceplate and insert the left end tabs into the slots at the left side
of the cartridge port.
3. Hold the bezel against the drive and slide the bezel right.
4. Press the right side of the bezel against the drive until the tabs snap into place.
CAUTION:
ESD Sensitive: Damage may occur to the drive cards. Make sure you follow the ESD
procedures in the “Personal Safety”section.
1. Press left on the two tabs.