Service manual

Drives without Load Handles
1-70 Revision P 96041
Sun Confidential - Internal Only
Quantum (Certance) LTO Bezel
To remove the bezel:
To replace the bezel:
SDLT 320 Bezel
To remove the bezel:
CAUTION:
ESD Sensitive: Damage may occur to the IBM drive cards. Make sure you follow the
ESD procedures in the “Personal Safety”section.
1. Remove the two m3 Torx pan head screws on the bottom corners of the bezel.
2. Pull the bezel straight away from drive faceplate.
1. Tabs
2. Standoffs
3. Target
2
2
1
3
L201_60
3
1. Orient the bezel with the target downward.
2. Align the screw holes over the two standoffs at the bottom corners of the cartridge slot.
3. Install the two m3 screws.
CAUTION:
ESD Sensitive: Damage may occur to the drive cards. Make sure you follow the ESD
procedures in the “Personal Safety”section.
1. Use a small screwdriver to press right on the two tabs on the right end in the gap between the bezel
and the tabs.
2. Lift the right end of the bezel slightly away from the drive face.
3. Slide the bezel left and lift away from the drive.