Service manual

96041 Revision P 1-69
Sun Confidential - Internal Only
Drives without Load Handles
To replace the bezel:
IBM LTO Bezel
The IBM bezel is attached to the front of the drive assembly.
To remove the bezel:
To replace the bezel:
1. Orient the bezel with the target as shown in the previous figure.
2. Insert the left tabs into the slots next to the cartridge slot.
3. Rotate the bezel against the drive faceplate and press until the right tabs snap into place.
4. Check that the bezel is against the drive faceplate at the left end.
CAUTION:
ESD Sensitive: Damage may occur to the drive cards and RLD card. Make sure you
follow the ESD procedures in the “Personal Safety”section.
1. Gently press the two tabs on the right side of the bezel and rotate the bezel to the left until the left
side tabs disengage.
2. Pull the bezel away from the drive faceplate.
1. Tabs
2. Target
L201_599
2
1
1. Orient the bezel with the target as shown in the previous figure.
2. Holding the bezel at a 30 degree angle to the drive face, insert the left tabs into the slots next to the
cartridge slot.
3. Rotate the bezel against the drive faceplate and press until the right tabs snap into place.
4. Check that the bezel is against the drive faceplate at the left end.