Service manual

Drives without Load Handles

1-68 Revision P 96041

Sun Confidential - Internal Only

Drives with a Cartridge Bezel

When removing following drives, make sure you remove the cartridge bezel from the

drive and replace the bezel in the new drive FRU. These drive FRUs do not ship with a

cartridge bezel.

• Hewlett-Packard LTO3 Ultrium

•IBM LTO3 Ultrium

• Quantum (Certance) LTO3 Ultrium

• SDLT 320 and 600

Follow the procedure below to remove and replace the cartridge bezel for the different

drive types:

HP LTO Bezel

The HP bezel is attached to the front of the HP drive assembly.

To remove the bezel:

1. Place drive on a work surface as shown below.

2. Press down on the two tabs as close to the drive face as possible. Use a small screwdriver, if

necessary.

CAUTION:

ESD Sensitive: Damage may occur to the drive cards. Make sure you follow the ESD

procedures in the “Personal Safety”section.

1. Tabs

2. Target

3. While holding pressure, rotate the bezel away from the drive until the top tabs are clear of the drive

faceplate.

4. Lift up on the bezel to release the lower tabs from the faceplate.

L201_600