Service manual

96041 Revision P 1-65
Sun Confidential - Internal Only
DLT Drives with Load Handles
1. Knob
2. Range of motion
3. Latch arm (shown disengaged)
2. Slide the replacement drive tray into the empty slot and tighten the drive tray latch by turning the
knob all the way to your right.
3. Pull back on the tray to ensure that the latch is secure.
Note: Three cables must be connected to the drive. The cable locations are shown below.
4. Connect the drive SCSI connector from the rear of the drive.
CAUTION:
Possible equipment damage: Make sure that the SCSI cable does not block the fan
before closing the door.
Possible cable damage: Make sure that you move the SCSI cable out of the way
before you close the drive door.
5. Connect the library-to-drive interface (P2) connector.
6. Connect the drive power cable.
7. At the rear of the library, close the drive access door and turn the door knobs all the way to the
right.
Note: For newer model libraries, push in the knobs and turn them all the way to the right.
8. If you are using the same SCSI ID for the new drive as for the old one, the library will automatically
assign that same address to the new drive and begin functioning as before. If the operator wants to
assign a new address, have the operator follow the drive configuration procedures in the L20 Tape
Library User’s Guide, part 95961.
9. Return the defective FRU according to your country’s warranty agreement.