Service manual

DLT Drives with Load Handles

1-64 Revision P 96041

Sun Confidential - Internal Only

8. Plug in the TTI cable.

9. Replace the cable cover and screw.

1. TTI cable (shown disconnected)

1. Screw

2. TTI cable

3. Cover

CAUTION:

Load/Unload problems: The latch must be fully loosened (disengaged) before you

slide the tray into the slot. If the latch arm contacts part of the library frame as it is

being tightened, it cannot be rotated to its fully locked position, and the tray will not

be firmly locked into the drive slot. This can cause alignment problems and the

camera can have problems reading the target.

1. Holding the new drive as shown in the following figure, turn the knob all the way to your right.

L201_327

L201_324