Service manual

DLT Drives with Load Handles

1-62 Revision P 96041

Sun Confidential - Internal Only

Replacement

1. Place the drive on a flat, sturdy work surface.

2. For terminating power, make sure that the replacement drive contains the same jumper as the

defective drive (remove the jumper from the defective drive and place it on the new drive if

required.).

3. Turn the replacement drive on its side and attach the crank handle.

1. Crank handle

4. Insert the power connector.

CAUTION:

Cable damage: Make sure that the cable shown below is routed at a right angle on

the drive tray and does not catch on the drive.

5. Align the cable at a right angle to the cover, keeping it as close as possible to the inside edges.

1. Cable

2. Handle escapement slot (see next step)

L201_328