Service manual

LLC Card SCSI Cable Assembly
1-34 Revision P 96041
Sun Confidential - Internal Only
Removal
1. Follow the procedures in “Repair Setup” on page 1-1.
2. Use a 3/16 in. driver to remove the four jack screws attaching the SCSI cable assembly to the
connector plate.
3. Slide the cable through the slot and into the library.
4. If the connector has conductive foam, remove the foam and place it on the new connector.
1. Screws
CAUTION:
SCSI interface problem: Notice whether the cable is connected to J18D or J18LS.
5. Disconnect P18D (lower) or P18LS (higher) from the LLC card.
1. P18D or P18LS