Service manual

External Fibre Channel Router
1-12 Revision P 96041
Sun Confidential - Internal Only
Replacement
1. Remove two mounting brackets from the old router and install them on the new router.
CAUTION:
Router weighs about 4 kg (9 lb). If necessary, have a second person hold the router
in place while installing screws and washers.
2. While supporting router, secure the router to the rack with four screws and washers.
1. Screws and washers
3. Connect the SCSI, fibre, and power cables from the rear of the router.
1. SCSI cables
2. Fiber cables
3. Power cable
Note: The internal fibre channel router card must be removed before powering on the library.
4. If requried, remove the internal fibre channel router card. See “Fibre Channel Router Card” on
page 1-5.
5. Power-on the library and make sure that it fully initializes.
6. Run diagnostic tests (described in the L20 Tape Library User’s Guide, part 95961).
7. If required, configure the router following the directions found in the StorageNet 3300 Fibre Channel
Router User Manual (STK part 461273-01).
8. Return the defective FRU according to your country’s warranty agreement.