Service manual

96041 Revision P 1-7

Sun Confidential - Internal Only

Fibre Channel Router Card

7. Pull back the module to release the card tab from the slot.

1. Tab

8. Remove the card and place it on an ESD mat.

Note: If the fibre channel router card is not being replaced, a SCSI Y cable and connector plate, must

be installed in its place.

9. If necessary, install connectors J1 and J2 of the SCSI Y cable (part 419671901) onto the SCSI

mounting plate, (part 309838803) using four screws (part 10097552). J1 attaches at the bottom

opening.

10. Attach the SCSI connector plate to the back of the chassis (from the inside) using the four screws

removed with fibre channel router card.

1. SCSI Connector Plate

2. Screws

11. Connect J3 of the SCSI Y cable to the LLC card.

L201_200