Service manual

Fibre Channel Router Card

1-6 Revision P 96041

Sun Confidential - Internal Only

Removal

1. Follow the procedures in “Repair Setup” on page 1-1.

CAUTION:

Component damage: Do not touch components on the LLC card. These components

are very delicate and are easily damaged through handling or electrostatic

discharge. Follow the ESD precautions in“ESD Precautions” on page xxii.

2. At the rear of the library, remove the SCSI and fiber cables from the Fibre Channel router card.

3. Remove the four screws that attach the card to the library frame.

1. Mounting screws

4. Disconnect the drawer interlock switch connector (J39). This cable is located across the top of the

Fibre Channel router card and attached to the LLC card. Place the cable aside.

5. Disconnect the Fibre Channel router power cable, J45 (not shown).

6. Disconnect the remaining cables.

1. Fibre router connectors

2. LLC connector (J18LS)

L201_226

L201_219