Service manual

xxiv Revision P 96041
Sun Confidential - Internal Only
a. If you are working on components from a small piece of equipment, attach the
free end of the coil cord to the grounding-kit work surface. In addition, be sure
that you touch an unpainted metal surface on the equipment before you touch an
internal component.
b. If you are working on components from a large piece of equipment, attach the
free end of the coil cord to a grounding jack or to an unpainted metal surface
inside the equipment.
Replace Components
7. Remove the defective component and place it on the work surface.
8. Remove the replacement component from its ESD-protective package, and install
the component in the equipment.
9. Place the defective component in the ESD-protective package.
Clean Up
10. Disconnect the ground cords from the equipment.
11. Reinstall all equipment covers and close all equipment doors.
12. Disconnect the coil cord from your wrist, and, if necessary, disconnect the ground
cord from the work surface.
13. Properly store the work surface and the other Field Service Grounding Kit items.