Service manual

96041 Revision P 3-3
Sun Confidential - Internal Only
Library Status Tool
The status window for the transfer appears.
CAUTION:
Equipment Damage: Do not attempt to perform any operations on the PC
or library until the operator panel displays DOWNLOAD COMPLETE. You will
damage the LLC card if you do not wait for the process to complete.
10. Wait for the following message: Download successful. Reboot is
needed for new code to take effect. Would you like to
reboot now (yes/no)?
11. Respond with ‘yes’ to reboot the machine and activate the firmware. Or, you
may press the power switch to the O position, then to the
— position.
Note: If you do not reboot or press the power switches, the old firmware version
will remain active. When the next reboot or power cycle occurs, the new
firmware will become active.
12. Verify that the version is correctly listed on the operator panel when the reboot is
completed.
■ Library Status Tool
The Library Status Tool is an embedded software that resides internal to the library and is
activated using a Web browser. Using the Library Status Tool you can:
• Load code.
• Reboot the library
• Generate reports on library, drives, fault symptom codes (FSCs), and tape inventory
The Library Status Tool uses Java-applets to send information using the Web.
Monitoring library operation can be done by using the Library Status Tool browser-based
Web interface (supplied at no cost).
Requirements
To use the Library Status Tool you must:
1. Make sure that the library is powered-on and initialized.
2. Set up the following network configuration using the operator panel on the library:
• The IP address for the library
• The subnet mask
• The network gateway
Check with your system administrator for these values.
See the L20 Tape Library User’s Guide, part 95961, for information about entering
these values.