Service manual

96041 Revision P 1-77
Sun Confidential - Internal Only
Drives without Load Handles
Note: Three cables must be connected to the drive. The cables are listed below.
4. Connect the drive SCSI connector to the rear of the drive.
5. Connect the library-to-drive interface connector.
6. Connect the drive power cable.
7. At the rear of the library, close the drive access door and turn the door knobs all the way to the
right.
Note: For newer model libraries, push in the knobs and turn them all the way to the right.
8. If you are using the same SCSI ID for the new drive as for the old one, the library will automatically
assign that same address to the new drive and begin functioning as before. If the operator wants to
assign a new address, have the operator follow the drive configuration procedures in the L20 Tape
Library User’s Guide, part 95961.
9. Return the defective FRU according to your country’s warranty agreement.