Service manual

Drives without Load Handles

1-76 Revision P 96041

Sun Confidential - Internal Only

5. Using a Torx driver, attach the four screws on the bottom of the drive tray in the sequence shown below.

1. Tighten first (near load handle)

2. Tighten second

3. Tighten third

4. Tighten last

CAUTION:

Load/Unload problems: The latch must be fully loosened (disengaged) before you

slide the tray into the slot. If the latch arm contacts part of the library frame as it is

being tightened, it cannot be rotated to its fully locked position, and the tray will not

be firmly locked into the drive slot. This can cause alignment problems and the

camera can have problems reading the target.

1. Holding the new drive as shown in the following figure, turn the knob all the way to your right.

1. Knob

2. Range of motion

3. Latch arm (shown disengaged)

2. Slide the replacement drive tray into the empty slot and tighten the drive tray latch by turning the

knob all the way to your right.

3. Pull back on the tray to ensure that the latch is secure.

L201_331