Service manual

96041 Revision P 1-75
Sun Confidential - Internal Only
Drives without Load Handles
Figure 1-16. Quantum Certance Drive Terminating Power Jumpers
1. Turn over the replacement drive and place it on a flat, sturdy work surface.
CAUTION:
For IBM drives only: Make sure that switches 1 and 2 (on the bottom of the IBM
replacement drive only) are both set to ON.
• Switch 1 = 9600 baud
• Switch 2 = Two stop bits
• The jumpers shown in the figures must be present.
2. Check the terminating power jumper locations for the drive you replace.
3. Replace the TTI and power connectors.
4. Carefully slide the drive tray over the drive.