Operating instructions

K3 Series Installation Instructions

ASSEMBLY

Adding Array Arms (K3F220, K3G220 only)

NOTE: Be sure the faceplate adjustment knob is on top when

installing the arms. (See Figure 1)

1. Slide array arm-right (W) into top of column assembly. (See

Figure 1)

2. Tighten two fasteners to secure array arm into place. (See

Figure 1)

Figure 1

3. Repeat Steps 1 and 2 for remaining array arms.

Adding Array Arms (K3G320 only)

NOTE: Be sure the faceplate adjustment knob is on top when

installing the arms. (See Figure 1)

1. Slide array arm-right (W) between brackets at top of column

assembly (A). (See Figure 3)

2. Fasten arm in place using one 3/8-16 x 2-3/4" socket head

screw (T) and one 3/8" nut (U). (See Figure 2)

Figure 2

3. Repeat Steps 1 and 2 for remaining array arms.

Adding Base - K3F Mounts (Free-standing)

1. Use four 1/4-20 x 1 1/4” flat head cap screws (F) to secure

table top base (C) to column assembly (A). (See Figure 3)

NOTE: Make sure front of base (long legs) is on the display

side when attaching base to column. (See Figure 3)

Figure 3

2. Tighten four existing bolts holding stand to column. (See

Figure 3)

x 2

(W)

(A)

Faceplate adjustment knob

(front view)

(A)

(W)

(U)

(T)

(C)

(F) x 4

(A)

front of base

x 4