Operating instructions

Installation Instructions K3 Series
15
Center Faceplate(s)
Pitch
1. Loosen knob on side of center faceplate assembly. (See
Figure 25)
2. Adjust pitch as desired. (See Figure 25)
3. Tighten knob to secure desired pitch position. (See Figure 25)
Figure 25
Roll
1. Loosen screws holding display to faceplate slightly.
2. Adjust roll position as the mounting holes on faceplate
allow.
3. Tighten screws to lock roll position.
Cable Management
1. Route cables from display through cable management
covers (B) as desired. (See Figure 26) and (See Figure 27)
2. Install cable management covers (B) onto array (A). (See
Figure 26) and (See Figure 27)
Figure 26
Figure 27
1
3
2
(B) x 3
1
1
1
2
2
2
(K3G310 shown as example)
1
1
2
2
(K3G310 shown as example)