Service manual

CONFIDENTIAL – DO NOT COPY
Page 8-14
File No. SG-0176
4. Row Active
The Bank Activation command is issued by holding CAS and WE high with CS and RAS
low at the rising edge of the clock (CLK). The DDR SDRAM has four independent banks;
so two Bank Select addresses (BA0, BA1) are required. The Bank Activation command to
the first read or write command must meet or exceed the minimum of RAS to CAS delay
time (tRCD min). Once a bank has been activated, it must be precharged before another
Bank Activation command can be applied to the same bank. The minimum time interval
between interleaved Bank Activation command (Bank A to Bank B and vice versa) is the
Bank-to-Bank delay time (tRRD min).
5. Read Bank
This command is used after the row activates command to initiate the burst read of data.
The read command is initiated by activating CS, CAS , and deasserting WE at the same
clock sampling (rising) edge as described in the command truth table. The length of the
burst and the CAS latency time will be determined by the values programmed during the
MRS command.
6. Write Bank
This command is used after the row activates command to initiate the burst write of data.
The write command is initiated by activating CS, CAS, and WE at the same clock sampling
(rising) edge as describe in the command truth table. The length of the burst will be
determined by the values programmed during the MRS command.