SmartWAV2-SerialMode_R1

SMARTWAV 2
Serial Mode
Vizic Technologies ©2020 | 46
defaults: beginning of the track 00:00:00 and
end of the track XX:XX:XX in time.
If the received point A and point B
parameters are equal, the system also resets
those points to their defaults: beginning of
the track 00:00:00 and end of the track
XX:XX:XX in time, this case can be used as a
default/reset point A and B markers.
The current audio playing position/point of
the channel is not modified by this
command.
A track must be already mounted in the
selected channel for this command to work.
*Note: For each single channel, once the
playing track reaches the point B, it is
automatically rewinded to the point A and
set in pause state (if loop points is active the
playing continues).
If the “Advance to Point” command is called
with a time parameter farther away in time
than the current set point B, the track will
continue playing until the end of the track,
then it will be rewinded to point A.
Examples (sent and
received commands)
Example 1:
Sent data:
-42,05,00,00,75,30,00,00,EA,60- Set channel 5
point A to time 00:00:30 (30000 milliseconds)
and point B to time 00:01:00 (60000
milliseconds).
Received data:
-4F- OK.