SmartWAV2-SerialMode_R1

SMARTWAV 2
Serial Mode
Vizic Technologies ©2020 | 45
7.8 Set A and B Points (In Milliseconds) - 42hex - ‘B’ ascii
Commands (host)
byte(s)
1.- 0x42 (hex), B (ascii).
2.- Channel 0x00 to 0x0D or 0xFF (hex) for All.
3.- Milliseconds A - High Byte.
4.- Milliseconds A - Medium High Byte.
5.- Milliseconds A - Medium Low Byte.
6.- Milliseconds A - Low Byte.
7.- Milliseconds B - High Byte.
8.- Milliseconds B - Medium High Byte.
9.- Milliseconds B - Medium Low Byte.
10.- Milliseconds B - Low Byte.
Responses (device)
byte(s)
1.- 0x4F (hex), O (ascii) - Success ACK or
0x46 (hex), F (ascii) - Fail NAK.
Description
This command sets the A and B points in time
(Milliseconds) for the received channel (0 to
13), the time is always calculated from the
beginning of the track. This command is
useful to set an A and B time markers for the
track, or to set loop regions.
Each time a command “Play Immediately”
or “Mount Track” is called, the point A and B
of the received channel are reset to the